Use - Cleanmaxx 02968 Mode D'emploi

3. Attach the nylon balloon:
– Pull it over the hanger. When you do this, make sure that the side with the hole line
points forwards.
– Pull the small elastic cord at the top over the collar section (12) on the hanger.
– Pull the large elastic cord at the bottom over the mounting fl ange (9).
The device is disassembled in the reverse order.

Use

PLEASE NOTE!
■ Always place the device with suffi cient clear space above it and on all sides on a dry,
fl at, solid, water-resistant and heat-resistant surface.
■ The device must not be left unattended during operation.
■ Be aware that the clamps with integrated weight may likewise become hot during use.
Allow them to cool down suitably before they are detached from the item of clothing.
■ Let the device cool down after every pressing process.
■ It is essential that you follow the care labels for the textiles which are to be
dried / smoothed!
For the best results, the device should ideally be used in a room that is as cool as
possible. We recommend a maximum room temperature of 25 °C.
2. If the item of clothing is to be steamed, fi ll the water tank (5) (see the "Filling the Water
Tank" chapter).
19
1. Set the height you want. To do this, open the clip (11), pull
out the telescopic rod (2) and then close the clip again. We
recommend pulling the telescopic rod out to its maximum
height.
3. Pull on the nylon balloon (see the "Assembly" chapter).
The nylon balloon should sit immediately below the
mounting fl ange (9) so that it can fully infl ate.
EN