Icematic F125C Mode D'emploi page 15

UNIT STOP
To stop the ice maker
always use the specific
hand disconnect switch.
Upon each re-starting, the
unit goes through the 3 min-
utes delay time, before it initi-
ates automatically the opera-
tion.
MONITOR LIGHT DESCRIPTION
The Electronic ice makers have five warning
lights located on the front of the cabinet that
monitor the following situations.
GLOWS:
to indicate that unit is under electri-
cal power
GLOWS:
bin full
GLOWS:
interrumption on water supply
GLOWS:
to signal an alarm condition due to
an excessive or a too low tempera-
ture reached by the cooling con-
denser (call service agent)
BLINKS:
3 minutes delay time at start-up
GLOWS:
freezer auger wrong rotation (call service
agent)
BLINKS:
to signal an alarm condition due to
an excessive temperature reached
by the freezer (call service agent)
DAILY PRE-CAUTIONS
To prevent the accumula-
tion on the ice of undesir-
ables bacterias it is neces-
sary to observe the following
indications.
Do not store anything in the
ice storage bin.
3'
Keep ice scoop clean and disin-
fected.
Keep the bin door closed.
During the cleaning of the floor
near the machine pay attention
that dust does not get sucked in
the unit by the fan motor.
To avoid damage to the unit:
Never shut-off the water supply
with the machine in operation.
Open and close the bin door with
gentle movement, never slam it
or kick it.
Do not place on top and around
the ice maker any sort of goods,
which can limit proper ventilation
and joepardize hygienic condi-
tions.
GB
15