Icematic F125C Mode D'emploi page 14

GB
HOW THE INSTALLATION IS MADE
IMPORTANT.
The machine installation has to be performed
by authorized Service Personnel.
The basic steps for the unit installation are
mentioned and illustarted in this paragraph.
Connect the plug to the electric cord in
compliance with the local electrical
codes.
Check machine is level.
The level can be corrected by
means of the leg levellers.
Water supply is connected using
the hoses supplied with the
machine.
Water drain is connected and set-
up properly using spiralled hose
which should have a minimum fall
of 3 cm per meter.
Open water shut-off valve.
Fit machine electric plug into its
receptacle.
Switch the main switch to the ON
position.
14
START UP
The unit is equipped with a
time delay so it starts after 3
minutes from the powerin
with the blinking of the Hi
Condensing temperature Red
LED.
NOTE.
The sound level of the unit in operation
should be lower than 70 db (A).
The authorized Service Agent will complete
an inspection of the unit interior.
The first pieces of flake ice will drop into the
storage bin within approximately 3 minutes.
While the machine is mak-
ing its first batch of ice
cubes it is recommended
that the interior of the stor-
age bin is cleaned with an
appropriate MILD DISIN-
FECTANT solution (liquid
algaecide).