F.F. Group EPHT 1000 Plus Notice Originale page 83

EPHT 1000 PLUS / SPS 250 / SPGT 350 & SPBC 230
Motor runs but blades
remain stationary
Machine does not cut
Increased vibration
Machine leaves ragged
finish and/or labours
Nut cannot be removed to
release cutting blade
Cutting blade fails to
rotate
Poor cutting performance
43 290
Multitool-attachment not properly
connected to power unit
Cutting blade damaged
Cutting blade damaged
Debris build up on cutting head
Blade nut loose
Cutting blade incorrectly fitted
Grass too high/dense
Cutting blade blunt
Cutting blade obstructed
Damaged thread on nut/shaft
Locking pin not located correctly
Cutting blade obstructed
Blade nut loose
Grass too high/dense
Cutting guard encrusted with
debris
Cutting blade blunt
Poor motor performance
Check for correct assembly
Replace the blade (always wear protective gloves)
Replace the blade (always wear protective gloves)
Clean cutting head and remove debris
Tighten nut ensuring the blade, rider plate and
dome washer are all present and central (always
wear protective gloves)
Remove cutting blade and refit in a fully central
position. Use guide rings on the blade to ensure
correct central alignment
Grass too high: Cut in stages
Grass too dense: Reduce rate of cutting every time
Flip/replace blade
Check underneath the machine and clear out as
necessary (always wear protective gloves)
Lubricate shaft to aid removal
Reinsert locking pin and apply light pressure
whilst rotating shaft
Check underneath the machine and clear out as
necessary (always wear protective gloves)
Tighten nut ensuring the blade, rider plate and
dome washer are all present and central (always
wear protective gloves)
Grass too high: Cut in stages
Grass too dense: Reduce rate of cutting every time
Clean inside of cutting guard
Flip/replace blade
Remove cutting system and slip plate and clean
slip plate groove
www.ffgroup-tools.com
English | 83