F.F. Group EPHT 1000 Plus Notice Originale page 82

82 | English
Problem
Machine fails to operate
Machine functions inter-
mittently
Motor runs but blades
remain stationary
Cutting blade hot
Saw chain dry
Saw chain/guide bar hot
Pole Pruner rips, vibrates,
does not saw properly
Saw chain/guide bar hot
Pole pruner cuts out
when sawing
TROUBLESHOOTING
Possible cause
43 288
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Thermal cut out
Extension cable damaged
Internal wiring of garden product
damaged
Multitool-attachment not properly
connected to power unit
Cutting blade blunt
Cutting blade has dents
Too much friction, due to lack of
lubricant
43 289
No oil in reservoir
Oil passage clogged
No oil in reservoir
Chain tension too high
Dull saw chain
Chain tension too loose
Dull saw chain
Chain worn out
Chain teeth are facing in the wrong
direction
Too much force applied
No oil in reservoir
Vent in oil filler cap clogged
Oil passage clogged
Chain tension too high
Dull saw chain
Chain over tensioned "too tight"
Over pressure applied to saw
during cutting
New chain
Hard wood
Wood is wet
Chain teeth facing wrong way/
direction
Over heating of tool
EPHT 1000 PLUS / SPS 250 / SPGT 350 & SPBC 230
Solution
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse
Allow tool to cool and try again
Inspect cable, replace if damaged
Contact Service Agent
Contact Service Agent
Check for correct assembly
Have blade sharpened
Have blade inspected/overhauled
Lubricate
Refill oil
Clean oil passage
Refill oil
Tension saw chain
Sharpen saw chain or replace
Tension saw chain
Sharpen saw chain or replace
Replace saw chain
Reassemble with chain in correct direction
Reduce force
Refill oil
Clean oil filler cap
Clean oil passage
Tension saw chain
Sharpen saw chain or replace
Retension chain
Reduce force applied to saw during cutting
Reduce force applied to saw during cutting
Reduce force applied to saw during cutting
Allow tool to cool down and restart
Reassemble with chain teeth in correct direction
Allow tool to cool down and restart