Hilti GX-IE Mode D'emploi page 10

3.3 Items supplied
Gas-actuated fastening tool with fastener guide, 2 batteries, charger, toolbox and operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4 Fastener guide 2
The fastener guide holds the insulation plug and in the driving process it directs the fastener to the desired
position in the material.
3.5 Fastener guide release slider
In the EJECT position, the slider releases the fastener guide for removal.
Status
EJECT
3.6 Belt hook
The belt hook can be extended in three stages.
Status
Position 1
Position 2
Position 3
3.7 Gas can
Observe the safety instructions provided with the gas can!
In order to operate the fastening tool, the gas can must be inserted in the gas can compartment.
The gas can status can be read from the LED display after pressing the GAS button.
The gas can must be removed before breaks between working, before maintenance and before transporting
or storing the fastening tool.
3.8 Indication of gas can status
After pressing the GAS button, the LED display indicates the status of the gas can.
Status
All four LEDs light green.
Three LEDs light green.
Two LEDs light green.
One LED lights green.
One LED blinks green.
One LED blinks red.
6 English
Meaning
Fastener guide release
Meaning
Position for attaching to a waist belt
Position for attaching to ladders, scaffolds, plat-
forms, etc.
Belt hook removed
Meaning
The level is between 100 % and 75 %.
The level is between 75 % and 50 %.
The level is between 50 % and 25 %.
The level is between 25 % and 10 %.
• Level is below 10 %. Replacement of the gas
can is recommended.
• The gas can is empty or is malfunctioning.
Replacement of the gas can is recommended.
Even when the level is indicated as "empty", the
gas can, for technical reasons, still contains a little
gas.
No gas can or the wrong type of gas can is present
in the fastening tool.
2208858
*2208858*