SMC Networks SMC7204BRB Guide D'installation Rapide page 5

1
Connecting the Hardware
Warning: Before you begin, turn the power off for all devices.
These include your computer(s), your LAN hub/switch
(if applicable), and the ADSL Barricade
Step 1. Connect the ADSL cable
Connect one end of the provided phone cable (RJ-11) to the port
labeled DSL on the Rear Panel of the device. Connect the other
end to your ADSL Microfilter/Splitter*.
*Note: ADSL splitters/microfilters are included with some models.
Step 2. Connect the Ethernet cable
If you are connecting a LAN to the ADSL Barricade
end of a provided Ethernet cable to hub/switch port and the other
to the Ethernet port on the ADSL Barricade
ADSL Barricade TM with a single computer and no hub, you must use
an Ethernet cable to attach the PC directly to the device.
7
TM .
TM , attach one
TM . If you are using the
Step 3. Attach the power connector
Connect the AC power adapter to the Power connector on the back
of the device and plug in the adapter to a wall outlet or power
strip.
Step 4. Power up your systems
Turn on and boot up your computer(s) and any LAN device such
as hubs or switches.
8