Installing Combination Oven into Wall Cabinet
NOTICES
Before installing the combination oven, be sure to
▯
verify the cabinet dimensions and electrical
connections.
Check that the cabinet opening is level and plumb for
▯
correct installation.
Remove Lower Oven Door Prior to
Installation
It is recommended to remove the traditional (lower) oven
door to help reduce the unit weight and provide easier
access to the latch levers located inside the oven. Do not
remove microwave, speed oven or steam convection
oven doors.
WARNING
9
The oven door is heavy and fragile. Use both
▯
hands to remove the oven door. The door front is
glass. Handle carefully to avoid breaking.
Grasp only the sides of the oven door. Do not
▯
grasp the handle as it may swing in your hand
and cause damage or injury.
Failure to grasp the oven door firmly and properly
▯
could result in personal injury or product damage.
To avoid injury from hinge bracket snapping
▯
closed, be sure that both latch levers are securely
in place before removing the door. Also, do not
force door open or closed--the hinge could be
damaged and injury could result.
Do not lay removed door on sharp or pointed
▯
objects as this could break the glass. Lay door on
a protected flat, smooth surface, positioned so
that the door cannot fall over.
14
Be sure to read all warn-
ings and cautions in the
installation manual
regarding the door
removal before attempting
to remove the door.
Open the door com-
pletely.
Flip latch levers on hinges
all the way down toward
you.
Holding the door firmly on
both sides and using both
hands, close the door
gently until it stops
against the latch levers,
about 30 degrees from
the closed position.
Carefully lift the door up
and out of the hinge slots.
Hold firmly; the door is
heavy.
Place the door in a conve-
nient and stable location
until you are ready to rein-
stall it. Lay the door on a
towel or section of protec-
tive foam padding to
avoid damage to the door
or the floor.