DRAMINSKI HMMP Mode D'emploi page 9

1. Assemble the sensor kit together with probes
onto the baler as shown in the diagram below.
The plate with two probes should be placed
directly onto the outlet part of the baler.
Assembly and installation of probes on the baler.
2. Connect the sensor kit to the yellow electronic
display module by using the connecting cable
attached to the rear of display unit.
3. Plug the display module into the power source by
using the power supply cable.
8
4. Place the display module in the cabin of the
tractor (for example on window panes) by means
of the suction cup; use the small lever to suck out
excess air. If the surface is not smooth enough,
you can use the sticker instead.
5. Press the ON/OFF button. If there is no hay or
straw in the outlet part of the baler, the display
screen will show "LO".