Numark STEALTH CONTROL Guide D'utilisation Simplifié page 4

CONNECTION DIAGRAM
Please study the connection diagram above.
Connect the STEALTH CONTROL's USB PORT to an available USB port on your computer, using the
included USB cable. The STEALTH CONTROL will be powered through your computer's USB bus.
(Optional) You can power the STEALTH CONTROL by connecting an optional 6V 1A power adapter to
the DC IN input on the STEALTH CONTROL. Please note that it is not necessary to have the adapter
plugged in for the STEALTH CONTROL to work. However, you should connect this adapter if your
computer is not able to supply enough power to the STEALTH CONTROL.
REAR PANEL CONNECTIONS
1. USB PORT – Please use the supplied USB cable to connect this port to an available USB port on
your computer.
connection.
2. DC IN – If your computer does not supply enough power through the USB bus, you may wish to
power the unit externally by connecting an optional 6V/1A adapter to this input and plugging the
adapter into a power supply.
COMPUTER
2 1
When plugged into your computer, the unit will draw power from the USB
3
4
POWER
SUPPLY
(OPTIONAL