Troubleshooting - Mafell KSS 60 36B Traduction De La Notice D'emploi Originale

Only for EC countries:
According to the European
Guideline 2002/96/EC, power tools
that are no longer usable, and
according to the European
Guideline 2006/66/EC, defective or
used battery packs/batteries, must
be collected separately and
disposed of in an environmentally
correct manner.
Battery packs/batteries:
7

Troubleshooting

Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Machine cannot be switched on
Machine stops while cutting is in
process
Saw blade jams as the machine is
advanced
Burn marks on the cut surfaces
Chip ejection blocked
Danger
Determining the causes for existing defects and eliminating these always
requires increased attention and caution. Pull the mains plug beforehand!
Cause
Discharge the
battery
Rechargeable
engaged in end position
Carbon brushes worn
Machine overloaded
Feed rate too fast
Blunt saw blade
Tension in the workpiece
Poor machine guidance
Uneven workpiece surface
The saw blade used is unsuitable
for the task or blunt
Wood is too damp
Extended operation
extraction
-26-
Li-Ion:
Please observe the instructionsin
section "Transport",page 25.
Subject to change without notice.
Elimination
rechargeable Charge the rechargeable battery
battery not Allow rechargeable battery to
engage completely
Take the machine to a MAFELL
customer service shop
Reduce feed speed
Reduce feed speed
Release the switch immediately.
Remove the machine from the
workpiece and replace the saw
blade
Use parallel stop
Straighten the surface
Replace saw blade
without Connect to an external extraction,
e.g. portable dust extractor