Filling the rinse aid dispenser
1
Daily use
1. Open the water tap.
2. Turn the knob until the programme marker is
aligned with the programme you want to set.
Set the correct programme for the type of
load and the degree of soil.
• If the salt indicator is on, fill the salt con-
tainer.
• If the rinse aid indicator is on, fill the rinse
aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Start the programme.
Using the detergent
1
30
2
1
2
1
2
2
3
To adjust the released quantity of rinse aid, turn
the selector between position 1 (lowest quanti-
ty) and position 4 (highest quantity).
A
B
3
Put the detergent or the tablet in compartment
(A) If the programme has a prewash phase, put
a small quantity of detergent in compartment
(B).
Using the combi detergent tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and the
rinse aid dispenser. The rinse aid indicator al-
ways comes on if the rinse aid dispenser is
empty.
1. Adjust the water softener to the lowest level.
2. Set the rinse aid dispenser to the lowest po-
sition.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Set the water softener to the highest level.
2. Make sure that the salt container and the
rinse aid dispenser are full.
1
2
4
4
www.zanussi.com