SEVERIN AH 7910 Mode D'emploi page 8

- Insert the adapter into a wall socket.
- Place the vacuum cleaner in the wall
bracket. The charging process begins
automatically and is shown by the charge
indicator.
- This appliance can remain on charge
indefinitely without damage or danger
and is therefore fully charged and ready
for use at all times.
- Whilst charging, the adapter will become
warm. This is perfectly normal and safe
and does not indicate a malfunction of
any kind.
- If the vacuum cleaner is not being used
for a long period of time, the capacity of
the battery may decrease by a certain
amount. However, full capacity will be
restored after several charge/discharge
cycles.
12 V operation
Insert the small plug of the connecting cable
into the 12V jack of the vacuum cleaner, and
the larger plug into the car's cigarette-lighter
socket.
- Power to run the cleaner will now be
supplied directly from the car's electrical
system, but charging the battery is not
possible in this mode, and the charging
indicator will not light up.
Picking up liquid matter
Before picking up liquid matter, ensure that
the rubber nozzle is fully inserted in the
suction aperture.
Crevice tool
The crevice tool can be inserted into the
suction aperture to clean crevices, corners
and other areas difficult to reach.
Crevice brush
The crevice brush can be fitted to the crevice
tool and is suitable for cleaning uneven
surfaces such as computer keyboards etc.
Operation
- Remove the vacuum cleaner from its
wall bracket.
- If required, fit any of the nozzle
attachments to the suction aperture.
- Switch on the appliance using the On/Off
switch.
●
Always ensure that the dust container is
emptied in good time, before the dust or
liquid matter collected reaches the level
of the inner suction tube.
- If the vacuuming power decreases during
operation,
automatically switch off to prevent the
battery from being over-discharged.
Recharge the battery if this occurs.
Cleaning
General
●
Before cleaning the appliance, remove
the vacuum cleaner from the wall
bracket.
●
To avoid the risk of electric shock, do not
clean the appliance nor the adapter with
water and do not immerse them in water.
- If necessary, the housing may be wiped
with a damp cloth. Wipe dry afterwards.
To empty the dust container
Reduced vacuuming power despite a fully
charged battery pack indicates that the dust
container and filter inlay must be emptied.
- Hold the vacuum cleaner with the dust
container facing downwards.
- Push the release button, open the dust
container in a downward and forward
direction, remove the filter and empty it.
- The filter can be cleaned by slightly
tapping it or by using a brush. The filter
can be separated from its holder by
simply pulling it out of its guide.
Should the filter be visibly dirty, it should
be thoroughly cleaned with soapy water;
make sure to let it dry completely
afterwards.
- The filter holder, dust container and
attachment tools may be cleaned the
same way.
8
the appliance will