Special Programming Art. 4660Kc - Comelit Group MT KIT 10 Manuel Technique

GROUP S.P.A.

Special programming Art. 4660KC

Fig. 1
Fig. 1A
Fig. 3
A number of special programming operations can be carried out on
Art. 4660KC according to the various system requirements.
1. On the terminal block of articles 4660KC, set the switch to
programming (red) (Figure 1A).
2. On the microswitches of the article (Figure 2), set the code for
the function to be programmed. Use the following table as a
reference.
3. On the terminal block of articles 4660KC, connect terminal
S with – (Figure 3).
10-second reset wait time (factory setting)
Deactivation of door lock confirmation tone and door lock time setting 2 seconds
Activation of door lock confirmation tone
Sending single call (factory setting)
Door lock release control normally open (NO) (factory setting)
Door lock release control normally closed (NC)
Door lock release active even with no call (factory setting)
Door lock release only enabled for the user called
MT KIT 10 44
Fig. 2A
1-second reset wait time
(factory settings)
Door lock time 8 seconds
Sending call repeated 3 times
Reset of all factory settings
Fig. 2
Art. 3309
Fig. 4
4. Wait for a programming confirmation tone and remove the
jumper between terminal S and -.
5. At the end of the procedure, make sure to have set the switch to
standby (white) (Figure 2A), removed the jumpers between
terminals S and - and turn all the microswitches to OFF (0) as
shown in Figure 4.
To carry out another special programming, repeat the above
operations from point 1 to point 5.
Dip switches ON
1,2,5,6,7,8
3,5,6,7,8
1,3,5,6,7,8
2,3,5,6,7,8
1,2,3,5,6,7,8
4,5,6,7,8
1,4,5,6,7,8
2,4,5,6,7,8
1,2,4,5,6,7,8
3,4,5,6,7,8
1,3,4,5,6,7,8
2,3,4,5,6,7,8
Configuration reference
number
243
244
245
246
247
248
249
250
251
252
253
254