Setting Of Optional Interphone Art. 2610 - Comelit Group MT KIT 10 Manuel Technique

Setting interphone (optional) Art. 2610
To extend the BRAVO KIT system by adding the optional
Interphone Art. 2610, the table necessary for defining the
required Interphone functions is given below.
DIP 1 DIP 2 DIP3 DIP 4
0 0 0 0
1 0 0 0
0 1 0 0
1 1 0 0
0 0 1 0
1 0 1 0
0 1 1 0
1 1 1 0
0 0 0 1
0 0 1
1
0 1 0 1
1 1 0 1
0 0 1 1
1 0 1 1
0 1 1 1
P2
2
1
P1
3 4
6
5
7 8
9
Button 1 function Button 2 function
Generic actuator Switchboard call
Single-residence
Switchboard call
Inter.
Switchboard call Two-residence Inter.
Single-residence
Generic actuator
Inter.
Generic actuator Two-residence Inter.
Doctor Switchboard call
Doctor Generic actuator
Single-residence
Doctor
Inter.
Doctor Two-residence Inter.
Single-residence
Two-residence Inter.
Inter.
Switchboard call Automatic switch-on
Actuator Automatic switch-on
Doctor Automatic switch-on
Single-residence
Automatic switch-on
Inter.
Two-residence Inter. Automatic switch-on
Video request and Automatic Switch-on function
Automatic Switch-on function (recommended only for systems
with 1 or 2 entrances). Press and immediately release the
dedicated pushbutton (pushbutton 2 - if the factory-settings
have been kept) to switch on the monitor. Automatic switch-on
is possible only when the system is idle.
Automatic switch-on can be disabled. To disable the function,
keep the dedicated monitor automatic switch-on pushbutton
pressed for more than 6 sec. A single confirmation tone will be
heard in the handset.
To enable the function, keep the same pushbutton pressed for
more than 4 sec. In this case, a double confirmation tone will be
heard in the handset.
1
2
2
3
V 3
4
4 C
5
C V
6
Video Request on monitor with brackets Art. 5714KC set as
Secondary (see JP1 in figure, in position S).
The Video Request function does not need enabling; it allows a
monitor to be switched on following a call for the user from
the external unit.
Use of Video Request function: press and immediately release
Pushbutton 2 (pay attention to the BRAVO KIT mode set by
means of the programming microswitches) to switch on the
monitor.
1
2
2
3
V 3
4
4 C
5
C V
6
MT KIT 10
D I P
JP1
D I P
JP1
43 MT KIT 10