Comelit Group MT KIT 10 Manuel Technique page 33

Optional card Art. 5733, Art. 5734 installation instructions
1
3
1
5
1 Remove the bracket and optional card from their package.
2 Secure the optional card on the plastic support of the bracket
with the special screws.
1. Terminal block:
P3: Monitor Pushbutton 3 contact. *
C3: Monitor Pushbutton 3 common contact *. Main common
contact from bracket Art. 5714KC (disconnect the wire to the
bracket connector to free all the common contacts).
P4: Monitor Pushbutton 4 contact. *
C4: Monitor Pushbutton 4 common contact. *
+P5: Monitor Pushbutton 5 contact for Art. 5733*. LED 5
positive input for Art. 5734.
- C5: Monitor Pushbutton 5 common contact for Art. 5733*.
LED 5 negative input for Art. 5734.
+P6: Monitor Pushbutton 6 contact Art. 5733*. LED 6
positive input for Art. 5734.
-C6: Monitor Pushbutton 6 common contact for Art. 5733 *.
LED 6 negative input for Art 5734.
2. Bracket male connector.
3. Female connector Art. 5733 or Art. 5734.
3 Connect the optional card female connector to the male
connector on the bracket.
4 Position the wires between the optional card and the bracket as
5
C V
D IP
V 3
4 C
C V
P
D I
2
D I
V 3
4 C
C V
1
2
4
2
5734
5734 !
6
3
4
5
5734 !
6
7
shown in the figure.
5 Fix the optional card to the connector on the back of the
Monitor with the special screws.
6 Only for optional card Art. 5734: cut and remove Monitor
Pushbuttons 5 and 6.
7 Only for optional card Art. 5734: fit the transparent Pushbuttons
(included in the article package) in the positions of Pushbuttons
5 and 6 as shown in the figure.
* To use the Pushbutton as a C.NO. contact (24V-100mA max) remove
the wire to the bracket connector and free the corresponding common.
MT KIT 10
2
1
3
2
1
31 MT KIT 10