Ibiza Light DJLIGHT80LED Manuel D'utilisation page 3

Power supply, wire Connection
Use a dedicated plug to connect the LED light and power. Make sure the unit is connected to the appropriate
power supply.
Installation of the units
Before positioning the light, ensure the stability of the installation site. Drive the screw into the screw hole on
the stand. Make sure that the units can't fall from the stand. The manufacturer cannot be held responsible for
damages due to bad installation of the units.
Warning
Carry the lights only by the handle.
Features
The control panel features 4 buttons and a 4-digit LED display.
Operation
1) When power is on, the digital LED display works with red dots.
When a DMX signal is present, the dot will be shiny.
2) DMX address code setting: Press "MENU" button. When the digital LED displays d001-d512, press "UP" or
"Down" to set the address code. The code ranges from 001-512.
3) IP code setting: Press "MENU". When IP.01-IP.64 is displayed, press "UP" or "DOWN" to set the address code.
The code ranges from 001-512.
4) Internal program running:
There are 5 built-in programs. Press "MENU" to choose one of the built-in programs from A1-A5: A1 is static
color mode, A2 LED jump function, A3 LED rainbow function, A4 LED sound active function, and A5 LED
strobe function, A6 is Auto Run and A7 scrolling effect.
Button Specifications:
A1 Solid Mode
A2. Jump Mode
A3. Rainbow mode
A4. Sound active mode
A5. Strobe Mode
R. Solid Red Color intensity
G. Solid Green Color intensity
B. Solid Blue Color intensity
U. Red+White Color Wash
D. DMX Mode
IP. IP Mode
Connection of Signal Cable
You can use the 3-pin XLR cable to connect the OUT socket of the first light and the IN socket of the following
light. Connect all the lights as below:
©Copyright LOTRONIC 2016
←UP/DOWN→ 1-19
←UP/DOWN→ 1-19
←UP/DOWN→ 1-19
←UP/DOWN→ 1-19
←UP/DOWN→ 1-19
←UP/DOWN→ 0-255
←UP/DOWN→ 0-255
←UP/DOWN→ 0-255
←UP/DOWN→ 0-255
d.512
IP.64
3
DJLIGHT80LED