Maxi-Cosi EasyBase Mode D'emploi page 9

Only use the EasyBase on a front-facing seat, which has been provided with an automatic 3-point belt,
provided it has been approved according to the ECE R16 standard or similar.
Correct positioning of the car seat belt is essential for the safety of your child. The seat belt has to be laid
along the blue marks on the EasyBase. Refer to the blue circled sticker on the top of the EasyBase. Never
lay the seat belt in any other way than described!
A. Installation
• ATTENTION! In some cases, the seat belts are positioned too far forward. This will make proper
installation impossible. Please refer to Chapter 9: car fitting list, for suitable seat types.
• ATTENTION! Sometimes, the lock part of the seat belt is too long and it will make contact with the base
of the EasyBase in a position that is too high. If this is so, the EasyBase cannot be secured properly. In
that case, choose another position in the car. If you are in any doubt or if you have any questions, please
contact the manufacturer.
• Place the EasyBase on the car seat (1). Make sure the anchor leg is fully folded out.
1
• Open the blue seat-belt clamp by pulling up the lever (2,1). Feed the shoulder and hip belt both through
2
the seat-belt opening (2,2).
• Pull the seat belts further, and lead them between the base and the blue seat-belt clamp. Next, feed them
3
through the second seat-belt opening (3,1). The seat belt is now in vertical position.
• Click the seat belt into the seat-belt lock of the car (3,2).
3
• Remove all play by pulling the shoulder part tight.
• Close the seat-belt clamp by pushing down the lever (4).
4
• Check correct mounting by pulling on the EasyBase.
B. Installing the anchor leg at the correct length
• ATTENTION! Always use the anchor leg for safe use of the EasyBase.
• ATTENTION! Make sure that the anchor leg is fully folded out and that it is stopped at the hinge point (5).
5
6 • Grip the anchor leg underneath the adjustment knob and push the adjustment knob on one side, using
your thumb (6,1).
6 • Keep the adjustment knob pressed and move the anchor leg downward until it touches the floor of the
car (6,2).
• ATTENTION! Ensure that the indicator on the foot of the anchor leg is green (7).
7
• Release the adjustment knob and lock the anchor leg until you hear a clearly audible 'click'.
• Ensure that the anchor leg is locked and that it will remain in position by trying to move the anchor leg
up and down without pressing the adjustment knob.
Instructions for use
GB
9