Function Selection - Vermeiren SE09 Manuel D'utilisation

Make sure that the free-wheel lever is in braking position BEFORE switching the wheelchair
ON. Electromagnetic brakes do NOT function if the wheelchair is in free-wheel mode. This
is indicated on the operating console. Driving is not possible.
4.3

Function selection

The function selection button (see part 5, Figure 1) allows you to switch between the adjusting
functions and drive functions. Press the button until the desired function is selected.
4.3.1 Adjusting your body position
CAUTION
 Be aware that the stability decreases when the wheelchair is moved from sitting straight to
inclined position.
 Make sure that there is enough space around the wheelchair to operate the backrest and seat.
If the SE09 console is installed on an electronic wheelchair with stand-up function, it is not
possible to adjust the body position with the SE09 console.
The wheelchair's adjusting functions can be operated using the function selection button.
Depending on your type of wheelchair, there can be up to 6 functions.

Press the function selection button to select the adjusting function.

To adjust your body position, move the joystick to the front or back.

To return to the basic sitting position, move the joystick to the back for each adjusting
movement.
The selected adjusting function is displayed on the drive and actuator indicator as shown below.
The display only shows the available/programmed functions in your wheelchair.
Adjust function
Seat inclination
Lift
Leg rest right
Unspecified
Risk of injuries or damage
Display Adjust function
Backrest inclination
Leg rest left
Leg rests simultaneous /
central footplate
None
7
SE09
2022-01
Operating console functions
Display
EN
NL