GALAGAR SMART 200 TIG PLUS Manuel Technique D'instructions page 26

Step two: Adjust the'selection knob'and select the output pulse LED (L11 is on); press the 'selection knob' again, the
pulse LED (L11) is twinkling; It means the output pulse function can be turned on or turned off.
Adjust the'selection
knob'and select the pulse LED
(L11 is on); Press the 'selection
knob' again, the pulse LED
(L11) is twinkling; It means the
output pulse function can be
turned on or turned off.
Step three: Press the 'selection knob' again, the output pulsed conditions transform by "ON" into "OFF" or
transform by "OFF" into "ON".
'selection knob'
Press the
again,
the output pulse
function is turned off.
Complete the adjustment after 3 seconds, the operation panel will return to original condition; welding current LED
(L4) is on. If the welding mode is TIG and the output pulse function is turned on, the pulse pilot light (L11) is on. If
the output pulse function is turned off, the pulse pilot light (L11) is off. In MMA mode, the pulse pilot light (L11) is off.
All preset parameters with hold function.
3.2. Layout for the front panel
1.Front panel Front panel Front panel Front panel
2.Operation panel Operation panel Operation panel Operation panel
3.Shield gas connecto Shield gas connecto Shield gas connecto Shield gas connector r r r is connected to the gas input pipe of torch.
4.Connector Connector the welder's negative polarity output.
Connector Connector
5.Aero socket Aero socket is connected to torch switch control wire (3 leads).
Aero socket Aero socket
6.Connector Connector Connector Connector The welder's positive polarity output.
SMART 200 TIG PULSE
SMART-200
HOT
GAS
START
MMA
ARC
FORCE
DISPLAY
SELECTION
1
f
DC TIG PULSE WELDER
2
3
4
5 6
4T LIFT
2T LIFT
4T HF
2T HF
26