GALAGAR SMART 200 TIG PLUS Manuel Technique D'instructions page 25

Les langues disponibles

Press the 'selection

knob'

Step two: Adjust the'selection knob'and select the pre flow time LED (L1 is on); Press the 'selection knob' again, the

pre flow time LED (L1) is twinkling; It means the pre flow time can be adjusted.

Adjust the 'selection knob' and

select the pre flow time LED (L1

is on); Press the 'selection knob'

again, the pre flow time LED (L1)

is twinkling; It means the pre

flow time can be adjusted

Step three: If the adjustment is completed, confirm the parameter by pressing the 'selection knob'; or the system will

confirm the parameter automatically after 3 seconds

If the adjustment is

complete, confirm the

parameter by pressing the

'selection knob'; or the

system will confirm the

parameter automatically

after 3 seconds

Output pulse selection: Press the 'selection knob'. Adjust the'selection knob'and select the pulse LED (L11 is on);

press the 'selection knob' again, the pulse LED (L11) is twinkling; It means the output pulse function can be turned

on or turned off. If the display is "ON", the output pulse function is turned on; if the display is "OFF", the output

pulse function is turned off. When the pulse LED (L11) is twinkling, press the 'selection knob' again, the output

pulsed conditions transform by "ON" into "OFF" or transform by "OFF" into "ON". Operation flow as follows:

Step one: 'Welding mode selection switch' select TIG 4T or 2T. Press the 'selection knob':

Press the 'selection

knob'

SMART 200 TIG PULSE

Select TIG 4T or

22300200t