Installation And Setting - Meister KB135M Traduction Du Manuel D'utilisation Original

(position O) and the speed control knob
(2) to the lowest setting (stop „–").
• Always protect eyes and ears.
• Other personal safety equipment
such as dust mask, gloves, apron and
helmet should also be worn.
• The maximum recommended
diameter of mounted wheels,
threaded cones and plugs shall not
exceed 55 mm and that the maximum
recommended diameter of sanding
accessories shall not exceed 80 mm
ATTENTION! The insertable tools
continue to run after the machine
is switched off. Wait until the machine
has come to a dead stop before
putting it down.
• To avoid hazards, damaged power
leads must be replaced by the
manufacturer or his customer service
representative.
Safety marking
The symbols on the housing mean the
following:
Important! Observe the
operating instructions!
Do not dispose of with
domestic waste!
Voluntary "geprüfte Sicherheit"
seal of quality (tested safety)
The housing is double
insulated
Electronic rotation speed
regulation
56
5400620-Hand-Schleifmaschine-man.indd 56 5400620-Hand-Schleifmaschine-man.indd 56
CE mark (conformity with
European safety standards)
IMPORTANT! Wear goggles.
IMPORTANT! Wear ear
defenders.
IMPORTANT! Wear a dust
protection mask.
BJ: Year of construction
SN: Serial number
SN: XXXXX The first two underlined
numbers give the month of
manufacture.
7 – Installation and setting
Inserting tools (Fig. 3)
ATTENTION! Switch off the
machine, turn the speed control
to the lowest setting and pull out the
power plug!
Press and hold down spindle lock (7),
screw off the tensioning screw of the
tool holder (6). Insert a collet chuck (8)
which fits the tool into the tool holder,
position the tensioning screw and turn it
loosely into position. Insert the tool and
tighten the tensioning screw with the
universal wrench (9).
– The maximum protrusion of the tool
is 23 mm
– The maximum mandrel length is
45 mm
ATTENTION! Ensure that the grip
guard (5) is always in position
when working!
19.10.20 13:50 19.10.20 13:50