Temperature Sensors - Steinbach Waterpower 5000 Mode D'emploi

Saving energy
To reduce energy consumption and related costs, you can take the following
measures:
• If you do not use the pool for a few days (e.g., on weekends), keep the
current water temperature approximately at the desired water
temperature. The heat pump needs time to heat up the pool water. If
there is a large temperature difference between the current water
temperature and the desired water temperature, it can take several days
until the desired water temperature is reached.
• If do not use the pool for more than a week, shut off the heat pump or
reduce the set water temperature.
• Do not use the heat pump when the ambient temperature falls below
15 °C.
• Use the timer (see "Operation" section) instead of running the heat
pump continuously in operating mode.
• Cover the pool to prevent heat loss due to wind.

Temperature sensors

The heat pump has four temperature sensors that measure the following temperatures
with an accuracy of ±3 °C:
- (14) current water temperature
- (15) ambient temperature
- (16) temperature of the compressor in the finned heat exchanger
- (17) temperature of the condenser in the finned heat exchanger
The temperature display can be called up during the operating mode and shows the
temperatures measured by the temperature sensors.
57