Steinbach Waterpower 5000 Mode D'emploi page 48

- Keep the openings free from foreign objects.
- When the heat pump is not in use, is being cleaned, or if a fault
occurs, always switch off the heat pump and disconnect its power
plug from the socket.
- Make sure that the actual operating voltage does not deviate
from the nominal value by more than 10% (see "Technical Data").
- As a protective device, the heat pump must have a circuit breaker
with a 16 A slow-blow fuse; this protective device may only feed
the heat pump. Even when using a protective device with all-pole
disconnection, it must still have a differential switch with a
differential current not exceeding 30 mA.
- Make sure that the electrical system to which the heat pump is
connected contains a grounding conductor.
- If a power plug is going to be installed for connection to the
mains, it must have a protection level of at least IPX4 and a
terminal for connecting the grounding conductor. The same
applies to the power supply cable, which must also have a
grounding conductor.
- Protect the power cable and the power plug from rain and
moisture.
- Protect the power cable and the power plug from damage.
Risk of injury for persons with impaired mobility or lack of
Improper handling of the device can lead to severe injuries or
damage to the device.
- This heat pump can be used by children aged 8 years and older
and by persons with reduced physical, sensory or mental abilities
or who lack experience and knowledge, provided they are
supervised or have been instructed in how to use the heat pump
safely and understand the resulting risks. Children are not
48
WARNING!
experience and expertise!