Work Instructions And Safety Precautions - Festo 8097522 Notice D'utilisation

MPS Industry 4.0 upgrade kit
®

The MPS must be used only:
•
for its intended purpose
•
when its safety functions are in perfect working condition.

5 Work instructions and safety precautions

General
•
Trainees should only work with the circuits under the supervision of an instructor.
•
Electrical devices (e.g. power packs, compressors and hydraulic units) may only be operated in training
rooms that are equipped with residual current devices (RCD).
•
Observe the specifications included in the data sheets for the individual components, and in particular
all safety instructions!
•
Malfunctions which may impair safety must not be generated in the training environment and must be
eliminated immediately.
•
Wear personal safety equipment (safety glasses, safety shoes) when working on circuits.
Mechanical safety
•
Switch off the power supply.
– Switch off working and control energy before working on the circuit.
– Only reach into the setup when it's at a complete standstill.
– Be aware of potential run-on times for the drives.
•
Mount all of the components securely on the profile plate.
•
Make sure that limit switches are not actuated from the front.
•
Risk of injury during troubleshooting.
Use a tool such as a screwdriver to actuate limit switches.
•
Set all components up so that activation of switches and interrupters is not made difficult.
•
Follow the instructions about positioning the components.
40
Malfunctions which may impair safety must be eliminated immediately!
© Festo Didactic 8097301