Olympus FL-700WR Mode D'emploi page 61

Front charge ind.: The LED light blinks to indicate when the fl ash is ready
to fi re.
Auto (To turn on the function) / Off (To turn off the function)
x You can only confi gure this function if you have set MODE (fl ash control mode) to
RC (P. 57) or SL M (P. 58).
Back light mode: You can set the back light of the control panel.
Auto (The back light turns on during operation.) /
On (The back light is always on.) / Off (The back light is always off.)
Back light timer: You can set when to turn off the back light of the control
panel.
You can select the time (in seconds) until the back light turns off automatically
when there is no operation.
From 1sec to 5sec to 15sec
Beep: A beeping sound indicates when the fl ash is ready to fi re.
Off (To turn off the function) / On (To turn on the function)
Reset: You can restore the default settings.
No (To keep the current settings) / Yes (To restore the default settings)
Safety Precautions
Read WARNINGS and CAUTIONS thoroughly to ensure safe usage. These
safety precautions protect the users and others and prevent property damage.
WARNING
• Do not use fl ash in places where it may be exposed to fl ammable or explosive
gas. Otherwise, fi re ignition or explosion may result.
• Do not directly solder the product or modify, remodel, or disassemble.
• Do not cover the light emitting area of the fl ash with your hand, and do not
touch the light emitting area after continuous fi ring. It may burn your skin.
• Water and foreign matter inside of the device may cause fi re or electric shock.
If the device is immersed in or exposed to water or foreign matter is found
inside of the device, turn off the power immediately and remove batteries with
care. Contact your dealer or consult an Olympus Authorized Service Station.
• To prevent a traffi c accident, do not direct the fl ash at a person operating a
motor vehicle.
Failure to observe the precautions indicated by this symbol
may result in injury or death.
61
EN