FUXTEC E522D Notice D'instruction D'origine page 22

Redback_Hedge trimmer E522D_de-en-fr.book Seite 22 Freitag, 4. März 2016 9:18 09
CAUTION!
Protect the battery contacts when the
battery is not being used. Loose metal parts
may short-circuit the contacts –
Explosion and fire hazard!
Adjusting the rear handle
Depending on the planned use the rear
handle can be rotated from the middle
position by 90° in either direction.
 Press the release button downwards (1.)
and simultaneously rotate the rear
handle to the left or right (2.), until it
clicks.
NOTE
The hedge trimmer will not turn on when the
rear handle is not securely engaged in the
respective end position.
Switching on/off the power tool
NOTE
Two-hand safety circuit
The hedge trimmer is switched on and
operated with both hands. One hand
operates the switch on the rear handle, the
second hand the safety switch on the
handlebar. If you release one of the two
switches, the cutter bar automatically stops.
Switching on
 Hold the hedge trimmer firmly with both
hands and ensure that there are no
persons (particularly children) or animals
in the immediate vicinity.
22
 Press and hold down the switch
interlock (1.).
 Press the switch (2.) and the safety
switch (3.). The hedge trimmer runs.
Switching off
 Release one of the two switches.
The cutter bar stops immediately.
Battery state of charge
 Press the button on the battery to check
the state of charge at the state of charge
indicator LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
E522D