FUXTEC FX-4MS142 Mode D'emploi Original page 43

Original Bedienungsanleitung FX-4MS142_de_en_fr_ita_rev01
Installing the protective shield
Install the blade guard on the driveshaft tube against
the gear housing. Tighten the holder of the guard so
that the blade guard does not move or slide down
during operation.
Mounting the lawn trimmer
Step 1:
Insert the key (1) into the hole in the gear head so that the gear shaft is locked. Unscrew and
remove the nut. Since it is a safety nut, please make sure that there is a left-hand thread here
Step 2:
mount the distance disk (2) and install the thread spool on the gear shaft. And then tighten it
by hand.
2
1
Warning!
Make sure that all components are correctly assembled and installed and that all screws are
tightened.