MAXA MI 2.6 Série Manuel Utilisateur Et Installation page 16

TEMP. setting
Timer
Sleep
Fan speed
Vertical louvers
Horizontal louvers (only for MI53)
√ : adjustable; - : not adjustable.
AUTOMATIC MODE
When the unit is ready for use, switch on the power: the LED
display panel of the indoor unit starts flashing.
1. Use the
2. Initial temperature setting is 24°C, increase or decrease 1°C by pressing ▲ or ▼ each time to set target temperature.
3. Indoor fan speed and blower louvers can be set by remote controller. The fan motor will run in low speed under Sleep
function.
NOTE
1. In the AUTO mode, the appliance can logically choose the mode of COOL and HEAT by monitoring the difference
between the actual ambient room temperature and the set temperature on the remote controller.
2. If the AUTO mode is not comfortable for you, the desired mode can be selected manually.
4. Air flow direction can be set at swinging mode or fixed at a certain angle.
COOLING MODE
1. The temperature setting range is 16°C ~ 31°C. The initial temperature setting is 21°C.
2. Push the button to select the FAN mode of AUTO, LOW, MED, or HIGH.
3. When the COOLING mode is selected, the fan may not start up straight away because the ANTI-HEATING mode is
present.
4. Air flow direction can be set
DRYING MODE
No temperature setting is allowed: fan always runs at low speed, blower louvers are adjustable.
HEATING MODE
1. The temperature setting range is 16°C
2. - When the HEATING mode is selected, the fan may not start up straight away because the ANTI-COOLING mode is
present.
FAN MODE
By pressing the FAN key several times, it is possible to adjust the fan speed between the three available speeds, or to
activate the AUTO mode. The operating mode appears on the display:
Auto ( ), Low ( ), Medium speed (
4) TEMP SETTING
After operation mode is selected, press ▼ or ▲ button to set the temperature.
▲ Button: Every time the button is pressed, temperature setting increases by 1°C.
▼ Button: Every time the button is pressed, temperature setting decreases by 1°C.
MODE
Set temperature range
Default
● TIMER MODE SETTING
Use the buttons
desired time.
15
mode select button to select
at swinging mode or fixed at a certain angle.
~ 31°C. The initial temperature setting is 27°C.
), High speed (
Auto
16°C ~ 31°C
24°C
and to set the timer programming as wished in order to switch on and off the unit at the
Auto Cooling
√ √
√ √
√ √
√ √
√ √
√ √
A
for MI26, MI35 or the RUN indicator (for MI53) on the
A
(AUTO).
).
Cooling
16°C ~ 31°C
21°C
Dry Fan
- -
√ √
- -
√ √
√ √
- √
Dry Fan Heating
-- -- 16°C ~ 31°C
25°C -- 27°C
Heating
√
√
√
√
√
√