Inserting/Changing Cutters; Mounting The Parallel Stop; Adjust Cutting Depth - Parkside POFA 12 A2 Traduction Des Instructions D'origine

GB IE
Inserting/changing
cutters
To insert and replace cutters, wear
protective gloves to prevent cuts
and burns.
1. Press the spindle locking button (10)
on the side of the device and keep it
pressed down.
2. Use the combination wrench (19) to
loosen the cap nut (11) as much as nee-
ded, so that the cutter can be inserted.
3. Release the spindle locking button (10).
4. Insert the desired cutter into the already
mounted collet chuck (12). The cutter
shaft must be pushed in at least 20 mm.
5. Use the combination wrench (19) to
tighten the cap nut (11) while kee-
ping the spindle locking button (10)
pressed.
Tighten the cap nut only when a
cutter is inserted. The collet chuck
might get damaged.

Mounting the parallel stop

1. Unscrew both retaining screws (15) on
the top side of the baseplate.
2. Now insert the parallel stop (22) into
the receptor (14) provided on the base-
plate (9).
3. Fix the parallel stop into the desired
position using the retaining screws (15).

Adjust cutting depth

The cutting depth may only
be set when the device is
switched off
32
1. Place the device with inserted cutter
onto the edge of the workpiece to be
processed while allowing space below
the cutter.
2. Unlock the cutting depth rough adjust-
ment by turning the locking knob (16)
anticlockwise about half way.
3.. Press the cutting depth rough adjust-
ment button (6) and keep it pressed.
4. Now move the drive unit (5) down-
wards/upwards and roughly set the
desired cutting depth.
5. Let go of the button (6).
6. Use the adjusting knob (7) for fine ad-
justment: one entire rotation corres-
ponds to 1 mm:
1mm(0.04")
Counter-clockwise rotation:
greater cutting depth.
Clockwise rotation:
lesser cutting depth.
7. Fix the desired cutting depth by turning
the locking knob (16) clockwise until
you sense resistance.
We recommend testing the cutting
depth adjustment by means of a test
cut on a reject piece.
To secure the finely adjusted cutting
depth, you can screw in the locking
screw (8) into the adjusting knob
(7) of the cutting depth fine ad-
justment from the underside of the
baseplate (9).