FUXTEC E608D Notice D'instruction D'origine page 32

Redback_Pole chainsaw E608D_de-en-fr.book Seite 32 Dienstag, 8. November 2016 11:15 11
Changing saw rail and saw chain
WARNING!
!
The teeth on the saw chain are very
–
sharp! Wear protective gloves when per-
forming any work on the chain.
Risk of injury!
An incorrectly attached saw chain will
–
cause the power tool to cut in an
uncontrolled manner! When attaching the
chain, observe the specified running
direction!
 Place the pole saw on any suitable flat
surface.
 Unscrew the handwheel anti-clockwise
until the saw rail can be moved by
hand (Œ.).
 Turn the chain tensioning wheel clock-
wise to push the saw rail as far as
possible onto the chain wheel (œ.).
 Detach the handwheel (3.) and remove
the chain cover (4.).
3œ
 Place saw chain around the saw rail
starting on the upper part of the rail.
Slide the chain in the slot around the saw
rail.
When attaching the chain, ensure that it
is in the correct running direction.
 Place the saw chain around the chain
wheel (5.).
 Place elongated hole of the saw rail on
the stud bolt and the guide bolt (6.).
 Attach the chain guard (7.). Tighten the
handwheel slightly (8.).
E608D