FUXTEC E608D Notice D'instruction D'origine page 29

Redback_Pole chainsaw E608D_de-en-fr.book Seite 29 Dienstag, 8. November 2016 11:15 11
E608D
 First press and hold the switch
interlock (Œ.).
 Then press the On/Off switch (œ.).
Switching off
 Release the On/Off switch.
Risk of injury!
!
When the On/Off switch is released, the saw
chain continue running briefly.
Battery state of charge
 Press the button on the battery to check
the state of charge at the state of charge
indicator LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Using the device
WARNING!
Never allow children to operate the pole
saw. Allow no person to use this pole saw
who has not read this user manual or
received adequate instructions for the safe
and proper use of this pole saw.
Before each use
 Check that all parts of the power tool are
present, firmly attached and undamaged.
 Check that the chain tension is correct.
 Check the chain lubrication.
 Check that there are no leaks.
Correct posture
Risk of injury!
!
Never work on unstable ground!
–
Never work while standing on a ladder!
–
Do not bend too far forwards when
–
working!
Use the power tool only when the
–
weather conditions and terrain are
favourable!
 Stand with both legs firmly on the ground.
 Beware of obstructions in the working
area.
 When working, always hold the power
tool with both hands!
This is how to use the saw correctly!
 Look over the working area and remove
any obstructions.
 Before starting work, check the safety of
the power tool (see Before each use ).
 Pick up the power tool in both hands.
 Switch the pole saw on before starting
the cut.
 Apply a uniform pressure to the unit,
however not excessive force.
 If possible, place the unit's tree claw on
the branch which is to be sawn.
œ9