Tunturi Pure U bike 1.1 Mode D'emploi page 6

Assembly step B
• Fit rear stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step C
• Connect the wires from upright tube
and main frame and hook up the
tension cable as shown in pictures
below (set tension knob to max. level
to ease the cable connection) before
sliding the upright tube in position.
• Use the enclosed Allen key to tighten
the fastening screws, turning them
clockwise.
6
Step 1
Step 2
Step 3
Remark:
First tighten all 6 bolts hand tight before
tightening them fully. This to avoid miss
alignment
• Fix the seat to the seat tube.
Assembly step D
• Lead the wires for hand pulse
reading through the hole towards the
display assembly opening.
Remark:
Avoid the wires to damage during
assembly..
• Fit the handlebar to the upright tube
by using the shown hardware..
Remark:
First put all screws/ bolts in correct place
before tightening them fully.