Olympus Stylus 1030 SW Mode D'emploi page 24

1 Insert the battery and close the battery/card
compartment cover and connector cover firmly
so that each lock makes the clicking sound.
2 Fill a bucket with fresh water, immerse the
camera in the bucket with the lens surface
downward and shake the camera thoroughly.
3 Press the o button several times in the
water and close/open the lens cover
repeatedly.
4 Furthermore, shake the camera further with the cover opened.
Follow the steps 1 to 4, then check if the lens cover moves smoothly.
En
If the lens cover does not move smoothly, rinse the lens face by placing it directly under
a strong stream of tap water and pressing the o button repeatedly.
Storage and Maintenance
• Do not leave the camera in an environment at high temperature (40°C (104°F) or
more) or at low temperature (-10°C (14°F) or less). Failure to do so may break down
water resistance.
• Do not use chemicals for cleaning, rust prevention, anti-fogging, repairing, etc. Failure
to do so may break down water resistance.
• Do not leave the camera in water for a long time. Failure to do so will cause
damage to the camera's appearance and/or deteriorate water resistance.
• In addition do not pour water over the camera directly from the water faucet.
• In order to preserve the water resistant feature, as with any underwater housing,
it is recommended that the waterproof packing (and seals) are replaced annually.
For the Olympus distributors or service stations where the waterproof packing
can be replaced, visit Olympus website for your local area.
Closing Battery/Card Compartment Cover and Connector cover
Battery/card compartment cover
Note: The included accessories (e.g. charger) do not offer shock or water resistance.
*1 as determined by Olympus pressure testing equipment in accordance to IEC
Standard Publication 529 IPX8 - This means that the camera can be used normally
under water at a specified water pressure.
*2 This anti-shock performance is confirmed by Olympus' testing conditions in
accordance with MIL-STD-810F, Method 516.5, Procedure IV (Transit Drop Test).
For more details of Olympus' testing conditions, please refer to the Olympus website
for your local area.
24
Connector cover