Giant UGT-199N Manuel D'installation Et D'utilisation page 87

THIS WARRANTY WILL NOT APPLY
1.To defects or malfunctions resulting from failure to properly install, operate, or maintain the unit in accord-
ance with the printed instructions.
2.If the installation does not conform to CSA and/or ETL Standards as well as any applicable national or local
building codes.
a.Product being installed in a corrosive environment
b.Condensate damage
c.Improper venting
d.Incorrect gas type
e.Incorrect gas or water pressure
3.To any damage or failure caused by abuse, accident, fire, floods, freezing, or other acts of God.
4.To any damage or failure caused by operating the heater without an approved temperature and pressure-
relief valve having been installed.
5.To any damage or failure caused by utilizing the heater in conjunction with any other energy saving device or
other source(s) of energy not approved Giant; or for other than use with potable water without any addi-
tives such as salt, chlorine, or chemicals other than those added for the purpose of rendering the water fit
to drink.
To any damages or failure caused by having affixed to the heater any replacement part(s) manufactured by
6.
another company or replacement part(s) not approved by the manufacturer.
7.7) To any damage caused by not having the water heater installed adjacent to a free flowing drain in the event
of water leakage.
8.If the heater is operated at water temperatures exceeding the maximum setting of the operating and/or high
limit control or the heater is not supplied with potable water, free to circulate at all times.
9.Incorrect sizing.
10.Improper maintenance (such as but not limited to scale build-up, freeze damage, or vent blockage).
11.Problems or damage due to fires, flooding, electrical surges, freezing or any acts of God.
12.If the heater is installed outside of Canada or the United States.
There is no warranty coverage on product installed in a closed loop application, commonly associated with space
heating only applications.
Use of an MCC-91-2 controller in a residential dwelling will reduce the warranty coverage to that of a commercial
warranty application except when an MCC-91-2 is used with a hydronic air handler for temperatures no higher
than 160°F (71°C).
This Limited Warranty does not apply to any product whose serial number or manufacture date has been de-
faced.
This Limited Warranty does not cover any product used in an application that uses chemically treated water
such as a pool or spa heater.
UGT Series Manual 43