Installation; Temperature Control - Signature SDP2701A+X Instructions D'utilisation

INSTALLATION

To fix stably, the appliance must be placed on a flat and solid
surface. It should not be laid on any soft material.
Choose a well-ventilated place. A space of at least 5cm must be
left at the sides and 10cm at the back of the refrigerator.
Choose a location where there is no heat source. Keep the
refrigerator away from direct sunlight or other appliance producing
heat.
Choose a dry and well-ventilated place where there is no corrosive
air.
TEST
Clean the parts of the refrigerator with lukewarm water on a soft
cloth or with a neutral detergent and with clear water, then wipe
them dry.
Notes: Electric parts of the refrigerator can only be wiped by dry
cloth.
Turn the thermostat knob on the "3" position and turn on electricity.
The compressor and the light inside the refrigerator begin to work.
Close the door and wait 30 minutes. If the temperature in the
freezer compartment decreased obviously, it shows that the
refrigerator system works well. When the refrigerator operates for a
period of time, the temperature controller will automatically set the
temperature on conditions that the door is not too often opened.
If the above steps are successful, the trial operations are finished.
The refrigerator works normally.

TEMPERATURE CONTROL

The temperature in the refrigerator compartment and in the freezer
compartment is controlled by the temperature controller installed
on the right side of the refrigerator compartment.
Turn the thermostat knob to regulate the temperature inside the
refrigerator.
The marks on the knob are not the exact number of the degrees of
temperature but the temperature grades from "0" to "7". The first
grade corresponds to a forced STOP of the refrigeration and the 7th
grade corresponds to the lowest temperature the refrigerator can
produce. Turn the knob from "1"position to "7"position, the
temperature decreases continuously.
Set the thermostat knob to "3-4"position for a normal use.
-24-