Accessories, Consumables; Technical Data - Hilti TE 3000-AVR Mode D'emploi

Masquer les pouces Voir aussi pour TE 3000-AVR:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
2.13 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled: The unit
must provide a power output in watts of at least twice the value printed on the type identification plate on the power
tool. The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in
the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and
starting boost. Generators with an inadequate power rating may cause damage to the power tool.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.
In addition, the power tool may not start or may cut out (no LED indication) if the electric supply is not within
specifications (see "Troubleshooting" section).

3 Accessories, consumables

Designation
TPS Theft Protection System with Company Card, Company Remote and TPS‑K key (optional)
TE 3000‑AVR detachable supply cord
Use the Hilti chisels or other tools listed below. With these you will achieve higher performance and longer
lifetime as the power tool and chisels have been optimized as a system.
Pointed chisels
Flat chisels
Wide-flat chisels
Asphalt chisel
Pointed flat chisel
Shank
Tamping plate

4 Technical data

Right of technical changes reserved.
NOTE
The power tool is available in various voltage ratings. Please refer to the type identification plate for details of the
power tool's voltage and power rating.
Designation
Width (mm)
TE‑H28P
SM 40
TE‑H28P
SM 50
TE‑H28P
38
FM 40
TE‑H28P
38
FM 50
TE‑H28P
80
SPM 8/40
TE‑H28P
80
SPM 8/50
TE‑H28P
115
SPMA 38
TE‑H28P
115
SPI 50
TE‑H28 SS 40
TE STP
150x150
150x150
TE STP
200x200
200x200
Width in
Length (mm)
inches
400
500
400
1¹⁄₂
500
1¹⁄₂
400
3¹⁄₈
500
3¹⁄₈
380
4¹⁄₂
500
4¹⁄₂
400
6x6
8x8
en
Length in
inches
16
20
16
20
16
20
15
20
16
17

Publicité

Table des Matières
loading

Table des Matières