Before Use - Hilti TE 3000-AVR Mode D'emploi

5.3.5 Personal protective equipment
The user and any other persons in the vicinity must
wear suitable eye protection, a hard hat, ear protec-

6 Before use

CAUTION
The power tool must be disconnected from the elec-
tric supply.
CAUTION
Check the insert tool for damage or uneven wear each
time before use.
6.1 Unlocking the power tool (theft protection
system)
NOTE
See section "Using the TPS Theft Protection System".
6.2 Connecting the supply cord to the power tool
CAUTION
The electric plug connector may be connected to the
power tool only when it is clean and dry and when
under no voltage (i.e. disconnected from the electric
supply). Disconnect the mains plug of the supply cord
from the electric power outlet before releasing the
electric plug connector from the power tool or before
cleaning it.
CAUTION
Disconnect the mains plug of the supply cord from
the electric power outlet after finishing the work and
before releasing the electric plug connector.
1. Remove the supply cord from the cardboard box.
2. Push the releasable electric plug connector into the
supply cord plug on the power tool as far as it will
go.
tion, protective gloves, safety footwear and respirat-
ory protection while the tool is in use.
3. While pushing it in under light pressure, turn the
keyed releasable electric plug connecter in a clock-
wise direction until it is heard to engage.
4. Plug the mains plug of the supply cord into the
power outlet.
6.3 Use of extension cords and generators or
transformers
Please refer to section 2 "Description".
6.4 Transport
CAUTION
Use the transport trolley or other means of convey-
ance whenever possible. The power tool should always
be carried by two persons if no transport trolley or means
of conveyance is available for use. Be aware that the
power tool plus transport trolley present a considerable
weight.
CAUTION
Do not park the transport trolley on an incline.
CAUTION
Take care to use only safe transport routes.
CAUTION
Take care to ensure that the trolley stands in a steady,
secure position.
6.5 Securing the power tool and chisels on the
transport trolley 3
Place the power tool on the locating pin provided on the
transport trolley and always secure it for transport by
closing the retaining bar.
Put the chisels in the holder provided, pushing them in
as far as they will go until held securely.
en
21