Beurer LB 45 Mode D'emploi page 19

Cleaning the ultrasound membrane, rinsing the base unit
Note
Empty the water from the base unit via the side rim in the direction indicated by the arrow. Ensure that no Empty the water from the base unit via the side rim in the direction indicated by the arrow. Ensure that no Empty the water from the base unit via the side rim in the direction indicated by the arrow. Ensure that no
water gets inside the device, e.g. via the fan opening.
1. Clean the ultrasound membrane with a cotton bud.
2. Empty the water from the base unit via the side rim. Observe the
markings on the device!
3. Should dirty residue remain in the base unit, pour some clean, fresh
water into the base unit and tip it out via the side edge.
Rinsing the water tank, replacing the water
Clean the water tank regularly, at least once a week if using daily. Use a mild cleaning product or vinegar/
vinegar-based cleaner.
1. Clean the thread of the screw plug using a soft brush.
2. Fill the water tank halfway with water.
3. Close the screw plug on the water tank.
4. Shake and turn the water tank over repeatedly.
5. Open and empty the water tank completely.
6. Repeat the process using clean, fresh water.
Cleaning the air humidifier inside and out
1. Empty the water from the base unit via the side rim.
2. Wipe the air humidifier with a damp cloth inside and out. Use only a mild detergent or vinegar/vinegar-
based cleaner to perform cleaning work.
Descaling
Descaling the ultrasound membrane
Hard water can cause limescale to build up in the device and, especially, on the ultrasound membrane. This
forms white deposits. Descale the device regularly.
1. Drop some descaler onto the ultrasound membrane.
2. Allow the descaler to work for 2 to 5 minutes.
3. After this time, clean the ultrasound membrane with the cleaning brush provided.
4. Rinse the base unit several times with clean, fresh water.
Cleaning inside the base unit
1. Dip a damp, soft cloth briefly in descaling solution.
2. Wipe the inside of the base unit with the cloth.
3. Carefully add some clean, fresh water into the base unit.
4. Empty the water from the base unit via the side rim.
5. Repeat the process using clean, fresh water.
Descaling the water tank
1. Fill the water tank halfway with water.
2. Add a small amount of descaler.
3. Close the screw plug on the water tank.
4. Shake and turn the water tank over repeatedly.
5. Open and empty the water tank completely.
6. Repeat the process several times using clean, fresh water.
19