Cresta DTX 320 Mode D'emploi page 18

ATTENTION：
ROUND BAR OF BAROMETER AND HISTORY AND
GRAPHIC DISPLAY OF THE AIR PRESSURE HISTORY FOR
THE PAST 3 HOURS .
You can read out the air pressure in hPa and in mmHg. Press "- " to change.
BACKLIGHT
Press the key "SNOOZE/LIGHT " to activate the display illumination for 7 seconds.
MOON PHASE DISPLAY
A B C D E F G H
A = New moon B = Increasing crescent C = First halfD =Increasing 3/4 E = Full moon
F = Decreasing 3/4 G = Last half H=Decreasing crescent
Note: The black segment display is alternating. There will be one position displayed stable for 6
seconds. This is the actual moon phase.
WIRELESS CONNECTION TO THE OUTDOOR SENSOR
 Press the key" +" to select a channel. You can read the data of up to 3 sensorsin one
main unit.
 Press and hold the key " ‐ " for 3 seconds to search for the outdoor sensor.
 There will be a temperature display in the main unit when the signal of the outdoor
sensor has been received successfully.
 There is a TX/CH button at the back of the battery compartment. Press to select the
channel of the outdoor sensor or hold TX/CH for more than 3 seconds to send the RF
signal manually.

The channel 1,2,3 on the main unit will be flashing alternating if all 3 channels receive
temperature data successfully. If only 1 channel succeeds, this channel number will be
flashing
.
As the weather is forecasted by barometer and temperature only,the
display may have a discrepancy with the actual weather in your
personal location
18