Publicité
Les langues disponibles
Les langues disponibles
The main unit is now connecting to the outdoor sensor. This process takes about 3 minutes
to show the outdoor temperature in the display if succeed. In case of a failure, please press
the " ‐ " button for more then 3 seconds to receive again.
As the RCC module is integrated inside the outdoor sensor, the automatic receiving of the
DCF 77 time signal can only be displayed succesful after the sensor has received this signal
and transmit by RF signal to the main unit. The sensor updates the actual dates around every
minute to the main unit.
When the outdoor sensor RCC reception process is going on, the RCC symbol is flashing in
the sensor display.
Once the signal has been received the flashing will stop and the RCC symbol is displayed
continuously.
NOTE: The distance of the RF transmission from the outdoor sensor is around 30 meter in
open area. The transmission distance is effected by obstacles such as a concrete wall. Please
make sure the distance between main unit and outdoor sensor is long enough to guarantee
a good reception.
MANUAL SET‐UP
If the batteries are installed the set‐up process will run fully automatic. You can set the main
unit manually aswell:
Press and hold key "MODE" for 3 seconds.
The display of the hour is flashing. Use "+" and"‐ " to select the hour.
Press "MODE" to confirm.
The display for the minutes is flashing. Use "+" and"‐"to select the minutes.
Press "MODE" to confirm.
The display for the year is flashing. Use "+" and"‐"to select the year.
Press "MODE" to confirm.
The display for the month is flashing. Use "+" and"‐"to select the month.
Press "MODE" to confirm.
The display for the date is flashing. Use "+" and"‐"to select the date.
Press "MODE " to confirm.
The display of the RCC symbol is flashing. Use "+" and"‐ " to select ON/OFF(make sure
select ON for radio controlled signal)
Press "MODE" to confirm.
The display for the time zone is flashing. Use "+" and"‐"to select the time zone.
Press "MODE" to confirm.
The display for the value of air pressure is flashing. Use "+" and"‐"to set the value*
Press "MODE"to confirm.
The display for the hi/lo air pressure is flashing. Use "+" and"‐"to select the hi/lo for 24
hour or for recorded hi/lo from the beginning.
Press "MODE" to confirm.
The display of the weather icon is flashing. Use "+" and"‐"to select the weather.
15
Publicité
