Güde GSF 1700-6,5 PS Traduction Du Mode D'emploi D'origine page 37

GSF 1700 - 6,5 PS | GSF 1700 - 6,5 PS E | GSF 1700 - 6,5 PS 230E
failure removal
Defect
Engine not starting or stopping
after a short while
Engine not starting
Engine not running smoothly
no drive or drive slipping
no or only minimum snow
ejection
machine getting stuck on small
unevenness.
Some snow remaining untreated
on the ground
Snow being thrown backwards
behind the machine
Unsteady running, strong
vibrations
no lighting
Causes
Too low level of the engine oil
Lack of oil protection has been
activated
Starter not working
Fuel tap closed
Overload protection activated
Petrol tank empty
Spark plug dirty from oil or
defective
Wrong gas lever position
Spark plug dirty
Air filter dirty
Clutch slipping
Ejection chimney blocked
Milling worm not rotating as the
clutch is slipping
Shear screw worn out
Skid set too low
Skid set too high
Skid set too high
Plough worn out
Components and screwed connec-
tion loosened
bulb defective
measure
Check the oil level
Add engine oil
7
Check or charge the battery
Open the fuel tap
Press the overload protection
Add petrol
Clean or replace the spark plug
Correct the settings
Clean the spark plug
Clean or replace the air filter
Adjust the cable
Consult with the customer service
centre
Switch the engine off and clean the
ejection chimney
Adjust the cable
Replace the shear screw
Correct the settings
10
Correct the settings
10
Correct the settings
10
Replace the plough
Switch the engine off and check /
tighten the screwed connection
Replace any damaged parts
Consult with the customer service
centre
Change the bulb
EnGlISH
33
20