SOMFY animeo KNX EnOcean Notice D'installation page 8

EN
A
PICTURES
[1] animeo KNX EnOcean Receiver 868 MHz
(Ref. 1860229)
[2] EnOcean PTM 200/PTM 210 Module has 2 channels
(A and B)
B
MOUNTING
[1] Switch off voltage supply.
Remove the cover of the animeo Motor Controller.
Place the animeo KNX EnOcean Receiver 868 MHz.
Switch on voltage supply.
The LEDs shine according to the diagram.
C
CONFIGURATION/STATUS INDICATION
Notes:
• Several animeo KNX EnOcean Receiver 868 MHzs should
not be programmed at the same time.
• A maximum of 20 PTM 200/PTM 210 channels can be
stored per animeo KNX EnOcean Receiver 868 MHz,
however not more than four per channel.
• The learning readiness ends automatically after 60
seconds if no input takes place.
[1] Train a sender
Press Reset/Prog button on Motor Controller for
approx. 2 seconds. Green LED lights up. Choose
channel with Reset/Prog button. Briefly operate the
"I" or "0" button of the trained sender 3 times.
LEDs confirm successful learning in.
[2] Delete a sender
Press Reset/Prog button on the Motor Controller for 2
seconds. Green LED lights up.
m The trained transmitter and the transmitter to be
deleted do not have to belong to the same channel.
Choose channel with Reset/Prog button. Briefly
operate the "I" or "0" button of the deleted sender
3 times. LEDs confirm successful learning in.
Somfy hereby declares that the radio equipment covered by these instructions is in compliance with the requirements of Radio Directive
2014/53/EU and the other essential requirements of the applicable European Directives.
The full text of the EU declaration of conformity is available at www.somfy.com/ce.
[3] Deleting all senders of a channel
Press Reset/Prog button on Motor Controller for ap-
prox. 2 seconds. Green LED lights up.
Choose channel by pressing shortly the Reset/Prog
button. Repeat until such time as the required LED
shines.
Keep Reset/Prog button pressed. After 5 seconds
all LEDs shine and confirm successful deleting of all
senders of a channel.
Release Reset/Prog button. LED confirm with a short
blinking the deleting of the required channel.
[4] Reset into delivery status/Deleting all senders of
an animeo KNX EnOcean Receiver 868 MHz
Press Reset/Prog button on Motor Controller for
2 seconds. Green LED lights up briefly. After
5 seconds all LEDs shine briefly. After a following
5 seconds all LEDs shine durably Release the Reset/
Prog button. Successful deleting of all senders and
channels is confirmed with a short LED blinking. RTS
radio module is again on delivery status.
m If the Reset/Prog button of the Motor Controller is
kept pressed for longer than 14 seconds, the Motor
Controller will be also reset!
animeo KNX enocean Receiver 868 MHz . REF. 5110901B -
8/16