Amplicom RingFlash 250 Mode D'emploi page 23

1� Disconnect the existing telephone con-
nection line from the phone currently
used�
2� Connect the end of the telephone cable
just disconnected in the telephone line
port LINE (10) in the RingFlash 250 base
station�
3� Then plug the telephone line supplied in
your telephone.
4� Connect the other end of the telephone
cable to the telephone connection port
TEL (12) in the RingFlash 250 base stati-
on�
5� Now connect the power adapter plug sup-
plied to the power outlet�
6� Plug the cylindrical plug on the power
adapter plug in the connection port for the
adapter plug (11) in the RingFlash 250
base station�
As soon as the RingFlash 250 base
station is connected to the power supply
network, the RingFlash 250 base stati-
on issues an acoustic signal to indicate
correct installation� If there is no acoustic
signal, disconnect the power adapter
plug from the power socket. Check the
connections on the RingFlash 250 base
station� Wait for 1 minute and plug the
power adapter back in the power socket�
Service−Hotline: Tel. 0844 800 6503
(Mon. to Fri. 9:00 - 17:00)
Using the RingFlash 250
GB
23