Télécharger Imprimer la page

Milwaukee 4270-20 Manuel De L'utilisateur page 4

Masquer les pouces Voir aussi pour 4270-20:

Publicité

Les langues disponibles

Les langues disponibles

1.
Always use safety strap when drilling overhead or on a vertical surface (see "Safety Strap" under "Operation").
Mounting can release.
2.
Clean the surface before attaching the drill stand to the work surface. Paint, rust, scale, or uneven surfaces decrease the holding
strength of the magnet. Chips, burrs, dirt and other foreign matter on the surface of the magnet base will also decrease holding power.
3.
Do not attach magnetic base to nonmagnetic grades of stainless steel. The magnetic base WILL NOT hold. The electromagnetic drill
press attaches magnetically to 3/8" or thicker ferrous stock. Do not use on stock less than 3/8".
4.
Wet connections are shock hazards. If the plug or connections get wet, turn power off to the outlet before unplugging the tool. Prevent
cutting fluid from traveling along the cord and contacting the outlet, extension cord connections or tool plug. Each time tool is plugged in, elevate
extension cord or gang box connections and arrange a drip loop.
Maintain labels and nameplates. These carry important information. If unreadable or missing, contact a MILWAUKEE service facility for a free
5.
replacement.
6.
WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause
cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
lead from lead-based paint
crystalline silica from bricks and cement and other masonry products, and
arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in
a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic
particles.
7.
Safety Strap
A.
Do not use near acids or bleaching agents.
B.
Do not use for overhead lifting.
C.
Do not use strap if webbing is cut.
D.
Webbing must be protected from sharp edges.
E.
All hardware must be in line with direction of pull for rated capacity.
page 4
SPECIFIC SAFETY RULES FOR ELECTROMAGNETIC DRILL PRESS
Volts Alternating Current
Amps
Double Insulated
No Load Revolutions per Minute
(RPM)
Underwriters Laboratories, Inc.
Canadian Standards Association
DANGER! To reduce the risk of injury, always keep hands,
rags, clothing, etc. away from moving parts and chips. Do
not try to remove chips while the cutter is rotating. Chips are
sharp and can pull objects into moving parts.
Volts
AC
Cat.
Only
No.
A m p s
4270-20
120
9.0
* Requires use of 1/2" drill chuck adapter, see "Accessories."
Symbology
Specifications
*Twist
No Load
Arbor
RPM
Bore
3/4"
450
HSS
Drill
Cutter
1/2"
1-1/2"

Publicité

loading