Güde GD 10 E Manuel D'utilisation page 28

SERVICE PROCEDURES
8
GB
SERVICE PROCEDURES
Continued
AIR OUTPUT, AIR INTAKE, AND LINT FILTERS
1. Remove upper shell (see page 6).
2. Remove fi lter end cover screws using 5/16" nut-driver.
3. Remove fi lter end cover.
4. Replace air output and lint fi lters.
5. Wash or replace air intake fi lter (see Preventative Maintenance
Schedule, page 5).
6. Replace fi lter end cover.
7. Replace fan guard and upper shell.
IMPORTANT: Do not oil fi lters.
E.
D.
Figure 13 – Air output, air intake and lint fi lters, 35.000 and
70.000 Btu/Hr.
E.
D.
Figure 14 – Air output, air intake and lint fi lters, 100.000
Btu/Hr.
(see fi gure 13 e 14)
A.Air Intake Filter, B.Filter end cover, C.fan guard
D.Air output fi lter, E.Lint Filter.
A.
B.
C.
A.
B.
C.
NOZZLE ASSEMBLY
1. Remove upper shell (see page 7).
2. Remove fan (see page 11).
3. Remove fuel and air line hoses from nozzle assembly (see
Figure 17, 18 or 19).
4. Turn nozzle assembly 1/4 turn to left and pull toward motor to
remove (see Figure 20).
5. Place plastic hex-body into vise and lightly tighten.
6. Carefully remove nozzle from the nozzle adapter using 5/8"
socket wrench (see Figure 21).
7. Blow compressed air through face of nozzle. This will free any
dirt in nozzle area.
8. Inspect nozzle seal for damage.
9. Replace nozzle into nozzle adapter until nozzle seats. Tighten
1/3 turn more using 5/8" socket wrench 4.5 to 5.1 N-m (40 to
45 in-lbs). See Figure 21.
10.Attach nozzle assembly to burner strap.
11.Attach fuel and airline hoses to nozzle assembly. See Fuel
and Airline Replacement and Proper Routing see page 9.
12.Replace fan (see page 11).
13.Replace fan guard and upper shell (see page 7).