Reset Settings; Configuration Of The Two Yokis Buttons; Configuration Via The Yokis Pro App; Configuration Without The Yokis Pro App - Urmet 1719/1 Notice D'installation Et D'utilisation

RESET SETTINGS

To restore default parameters of the device after entering programming mode, hold buttons
pressed for longer than 3 seconds. The system will beep twice times to confi rm and exit programming.

CONFIGURATION OF THE TWO YOKIS BUTTONS

CONFIGURATION VIA THE YOKIS PRO APP

The VMODO video door phone Ref. 1719/1 or 1719/2 is perfectly integrated in the YOKIS PRO Installer
App.
It is possible to confi gure its two Yokis buttons using the app and download the confi guration to the video
door phone, following the standard procedure (pressing one of the two buttons twice).
Button corresponds to channel 1,

CONFIGURATION WITHOUT THE YOKIS PRO APP

Alternatively, the two Yokis buttons can be confi gured without using the YOKIS PRO app: the two buttons
can be set up as a two-button Yokis remote control.
DIRECT MODE
1 - Briefl y press the button you want to connect 5 times (**) (E5).
The LED on the video door phone will start fl ashing for 30 seconds, indicating that a connection is
waiting.
(**) Each pressure must be faster than 0.7 seconds long.
2 - While the video door phone LED is fl ashing, press briefl y with the tip of a pencil into the "connect" hole
of the receiver (R) (located at the front or back of the receiver).
The LED on the video door phone will stop blinking.
Important: The receiver must be powered.
On the video door phone,
the LED lights up only
if the radio transmission
was successful.
To cancel a connection, simply repeat the same procedure.
CENTRALISATION IN DIRECT MODE
A control can be centralised by repeating the same procedure on up to four receivers per button. In addition,
use the Radio Bus.
RADIO BUS MODE
It is possible to connect an unlimited number of receivers to each other, thus creating a "Bus Radio". This
can be used to:
• send controls to groups of receivers on the radio bus (see "Yokis Radio Quick Installation Guide")
• send a control from the video door phone to a receiver which is out of direct range
• centralise the control of all lights or of all shutters or of all lights and shutters together. All Yokis receivers
are Bus Radio compatible.
The window shutter controls may also be sent via lighting modules and vice versa. For further information on
the Radio Bus, refer to the "Yokis Radio Quick Installation Guide" or the www.yokis.com website.
HOW TO CREATE THE RADIO BUS BETWEEN DIFFERENT RECEIVERS
Quickly press "connect" on receiver 1. Its LED will starts blinking
"connect" on receiver 2
18
.
button to channel 2.
. While the LED is blinking, press
and
DS1719-004