WIKA WUD-20 Mode D'emploi page 22

5. Commissioning, operation
Parameters Description
DISU
EN
DISO
MBA = Start of measuring range
MBE = End of measuring range
5.3.5 Error display
Error Description
ATT Setting lies outside the range
(To acknowledge the error display, press the main key)
OL Pressure too high, measuring range exceeded > approx. 5 % (display blinks)
UL Pressure too low, below the measuring range < approx. 2 % (display blinks)
22
Display update
Display of zero offset
(The setting has no influence on the output
signal. Only the display-indicated value is set.)
Setting range
0.2 / 0.5 / 1 / 5 / 10 / 60 s
±10 % of span
WIKA operating instructions Ultra High Purity transducer, model WUD-2x
Factory setting
0.2 s
0 %