Triangle GAMME STRATOS 260 Mode D'emploi page 18

ENGLISH
!
Place the protective washer C under the stainless steel spike A. Adjust the adjusting keys to obtain the best stability and good perpendicularity
between the speaker B and the base D in relation to the floor.
INSTALLATION OF ACCESSORIES FOR THE SOLIS
!
Unpack the equipment. Place the legs with the side shown in the figure facing forward (you should be able to see five fixing holes, four for the
base 2 and one for the stainless steel spike 1). You can insert sand into hole 5 in order to weight the leg. The base 4 will block the hole. Fix the
base 4 and the stainless steel spike 3. The base is fixed using the four M6 screws (use the spanner and screws provided). Screw the four
screws completely for the base and the stainless steel point. The hole 6 allows the amplifier / speaker connection cable to be passed along the
internal leg walls. The cable should exit the other end of the foot through the opening provided.
!
Raise the adjusting keys 1 with the counternuts 2 on the base 5. Normally, parts 3 and 4 are already fixed on the base 5. The counternut 2
prevents movement of the adjusting keys. Turn the unit over and select a suitable place to install your system.
!