Festool RAS 115 E Notice D'utilisation D'origine page 12

Rotary sander
Technical specifi cations
Power
Rotational speed
Max. speed*
Sanding pad
Connecting thread of drive shaft
Weight (without cable)
Protection class
*Max. possible speed with faulty electronics.
The specifi ed illustrations are at the beginning of the
Operating Instructions.
Symbols
Warning of general danger
Wear ear protection.
Wear eye protection.
Read the Operating Instructions/Notes!
n Rated speed
1 Intended use
As specifi ed, the machines are designed for sanding
wood, plastic, metal, stone, composite materials,
paint/varnish, fi ller and similar materials.
Materials containing asbestos must not be pro-
cessed.
To guarantee electrical safety, the machine must
not be damp nor operated in a damp environment.
The user bears the responsibility for damage
and accidents caused by improper use.
2 Safety instructions
2.1 General safety instructions
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock, fi re
and/or serious injury.
Save all warnings and instructions for future ref-
erence.
The term „power tool" in the warnings refers to
your mains-operated (corded) power tool or battery-
operated (cordless) power tool.
• Never allow children to use the power tool.
2.2
RAS 115 E
Specifi c safety instructions for sanding and wire
brushing
500 W
-1
1350 – 3800 min
a) This power tool is intended to function as a
-1
5500 min
up to dia. 115 mm
M 14
1.6 kg
/ II
b) Operations such as grinding, polishing or cut-
c) Do not use accessories which are not specifi -
d) The rated speed of the accessory must be at
e) The outside diameter and the thickness of acces-
f) Threaded mounting of accessories must match
g) Do not use a damaged accessory. Before each
h) Wear personal protective equipment. Depending
12
Machine-related safety instructions
sander and wire brush. Read all safety warnings,
instructions, illustrations and specifications
provided with this power tool. Failure to follow
all instructions listed below may result in electric
shock, fi re and/or serious injury.
ting-off are not recommended to be performed
with this power tool. Operations for which the
power tool was not designed may create a hazard
and cause personal injury.
cally designed and recommended by the tool
manufacturer. Just because the accessory can
be attached to your power tool, it does not assure
safe operation.
least equal to the maximum speed marked on
the power tool. Accessories running faster than
their rated speed can break and fl y apart.
sories must be within the capacity rating of your
power tool. Incorrectly sized accessories cannot
be adequately guarded or controlled.
the grinder spindle thread. For accessories
mounted by fl anges, the arbour hole of the ac-
cessory must fi t the locating diameter of the
fl ange. Accessories that do not match the mount-
ing hardware of the power tool will run out of
balance, vibrate excessively and may cause loss
of control.
use inspect the accessory such as abrasive
wheels for chips and cracks, backing pad for
cracks, tear or excess wear, wire brush for
loose or cracked wires. If power tool or acces-
sory is dropped, inspect for damage or install
an undamaged accessory. After inspecting and
installing an accessory, position yourself and
bystanders away from the plane of the rotating
accessory and run the power tool at maximum
no-load speed for one minute. Damaged acces-
sories will normally break apart during this test
time.
on application, use face shield, safety goggles or
safety glasses. As appropriate, wear dust mask,
hearing protectors, gloves and shop apron ca-
pable of stopping small abrasive or workpiece
fragments. The eye protection must be capable
of stopping fl ying debris generated by various